Doepfer Doepfer A-100 DIY Kit 1

Main features:

Do-it-yourself construction of a carrying case for the A-100

Power supply with external transformer (AC output)

For safety reasons, no dangerous voltage accessible inside the enclosure.

Output voltages / currents: + 12V (max. 1200 mA), -12V (max. 1200 mA)

Encapsulated external transformer

2 bus passes

Four front 84hp rails (length 427mm) for module mounting, including 8 mounting screws

Approximately 160 M3 nuts that need to be inserted into the front rails (as the nuts can be slid into any position, other manufacturers' modules with different mounting hole positions can also be mounted without gaps).

Cable for connections between power supply and bus cards

Measured sketches (for drilling holes in the right positions for mounting on power supply and bus card)

Tip for building a wooden crate (sketch + list of all necessary parts of the wooden crate)

Additional installation materials such as distant screws, nuts or bolts (eg for bus panels, power boards, rails) are not included as these parts depend on the type of enclosure built by the customer.

An external transformer with 14-18V / 2.4A AC is required for the operation of the kit, the transformer current must be twice the value of the current +/- 12V DC, the maximum value is 2.4A (corresponding to 1200mA for + / - - 12V DC). An even smaller current output is possible; the output current from the power supply is half the current of the external transformer as currents are required for both voltages +/- 12V (for example if the transformer emits max 1000mA, the maximum supply current is 500mA for +/- 12V )

If + 5V is required (eg for some modules from other manufacturers) you can use the + 5V adapter A-100AD5.